How to replace drum unit for Brother FC-9460CDN, MFC-9560CDW, MFC-9970CD printer
Author: Tin Nguyen Views: 135 Created: 2017-03-24 23:29 Last Updated: 2017-03-24 23:30 0 Rating/ Voters

How to replace drum unit for Brother FC-9460CDN, MFC-9560CDW, MFC-9970CD printer

1. Make sure the machine is powered on. Press the front cover release button and then open the front cover



2. Hold the green handle of the drum unit. Pull the drum unit out until it stops.


3. Turn the green lock lever (1) at the left of the machine counterclockwise to the release position. Holding the green handles of the drum unit, lift the front of the drum unit and remove it from the machine.



NOTE: Hold the green handles of the drum unit when you carry it, do not hold the sides of the drum unit.

We recommend that you place the drum on a clean, flat surface with a sheet of disposable paper or cloth underneath it in case you accidentally spill or scatter toner.

 

4. Hold the handle of the toner cartridge and slightly push it toward the machine to unlock it. Then pull it out of the drum unit. Repeat this for all the toner cartridges.



5. Unpack the new drum unit and remove the protective cover.




 6. Hold the handle of the toner cartridge and slide the toner cartridge into the drum unit then slightly pull it toward you until you hear it click into place. Make sure that you match the toner cartridge color to the same color on the drum unit. Repeat this for all the other cartridges.



7. Make sure the green lock lever (1) is in the release position shown in the illustration.



8. Match the guide ends (2) of the drum unit to the triangle marks (1) on both sides of the machine, and then gently slide the drum unit into the machine until it stops at the green lock lever.



9. Turn the green lock lever clockwise to the lock position.

 

10. Push the drum unit in until it stops.

 

11. Close the front cover of the machine.

 

12. When you replace the belt unit with a new one, you need to reset the drum unit counter by completing the following steps.

 

a. Press MENU8 (Machine Info), 4 (Reset Parts Life).

 

b. Press the UP or DOWN ARROW key to select Drum. Press the OK key.

 

c. Press 1 to reset the drum unit counter.

 

d. Press STOP/EXIT.

 


Rss Comments
  • There are no comments for this article.
Info Add Comment
Nickname: Your Email: Subject: Comment:
Enter the code below:
Quick Jump Menu